DJI Avata Strobe Anti Collision Night Light Snap-In holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Snap-in mount for the VIFLY anti-collision strobe light and DJI Avata (down pointing)
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 98
- Makes
- 0
- Views
- 819
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
I wanted a quick-mount solution to securely mount a VIFLY strobe to underside of my DJI Avata. Velcro didn't feel secure enough. This takes advantage of the 2 little open triangles on the left and right sides of the drone.
You can find the strobe on amazon by searching for ‘VIFLY anti-collision strobe’.
I printed this using both ASA and tough PLA - both work very well. I uses .2 layer hight and 6 perimeters to ensure the clips are solid.
I made the design a little on the stiff side - it takes some force to snap in and remove. If you want it easier, set your xy size compensation to -.05 or -0.1.
In the US, FAA regulations require a white strobe on the top of your dron… but then you can't see the Avata from the ground. My solution is 3 strobes - a white strobe on the top so helicopters can see it, a red blinker on the underside so I (or a spotter) can see it, and another red strobe on the ground at the takeoff point, which makes it much easier to land at night.