1 / 3
Low-Friction Bambu P1S Y-Splitter - No couplers, no magnets — image 1
1 / 3

Low-Friction Bambu P1S Y-Splitter - No couplers, no magnets

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A PTFE/Bowden Y-Splitter with low friction, featuring an M3 slot for printer attachment. Fits the Bambu P1S.

Rating
5 / 5
Likes
45
Downloads
338
Makes
4
Views
2,945
Reviews
5

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

A small adaptation of the great low-friction bowden/PTFE-tube Y splitter by BlindMaker. This remix adds an M3 slot flange that allows to fix the splitter on the rear side of the Bambu P1S (the X1C should work as well), using an M3*10 screw with one or two washers (depending of the splitter shall remain movable or not). Just remove the screw from the printer housing, as indicated in the picture below, and install the splitter there.

You will need to print one top part and a bottom part of your choice - either for M3 inserts or nuts. For a list of required screws, print and usage instructions and the engineering history behind this model, please refer to the page of the original model by BlindMaker.
Furthermode, if you own an X1C and prefer using magnets, you can find the corresponding models there.

If you prefer to have a 3-way splitter instead of a Y-splitter, also featuring a flange, check out this similar remix by WayneC.

Happy printing!

Tags