Moza RS V2 thumbstick cap
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Thumbstick cap replacement
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 151
- Makes
- 0
- Views
- 1,533
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- Creative Commons — Attribution — Noncommercial
Moza RS V2 thumbstick cap replacement. It's narrower at the bottom to allow for wider motion range when your encoders are worn and register signal at the very edge of the movement (like mine). It solves as well the issue of pushed in caps that blocks the movement almost completely.
I've printed mine on .16 layer height, they fit very tightly. If your printer is calibrated differently you can scale it a bit in slicer or heat up the pins or cap itself to make it softer and then put in on encoder pin.
Use supports for concaved surface for thumb area.
It should fit more Moza wheels if the same encoders are used.