1 / 4
D-cell Battery to 18650 / 26650 adapter for Maglite — image 1
1 / 4

D-cell Battery to 18650 / 26650 adapter for Maglite

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Convert a D-cell Maglite to use 18650 or 26650 li-ion cells

Rating
0 / 5
Likes
25
Downloads
118
Makes
1
Views
1,359
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

Li-ion safety warning

  • For use with “protected” li-ion cells only. Unprotected cells can be discharged too much making them hazardous when re-charged.
  • Older Maglites are sealed tubes with rubber o-rings at each end. In the worst-case scenario, a failed 18650 cell can discharge up to ~6 liters of gas (~10 liters for 26650) . With two cells, that's 12-20 liters in a very small space creating immense pressure. If the o-rings don't release some gas, then the cap will pop off violently when you go to replace the cells potentially causing serious injury.
  • To mitigate these risks, consider removing one or both o-rings. Without o-rings, the aluminum threads are more susceptible to corrosion, so keep the flashlight away from moisture.

Install

  • Open Maglite and remove spring and extra bulbs from end-cap.
  • Compress/flatten the spring with a bench vice and/or pliers.
    • Make sure to keep the pig tail in the center as that will be the part that contacts the negative terminal of the battery.
    • Preserve the largest diameter part of the spring that rests against the machined part of the aluminum end-cap - the part that is the natural aluminum color as opposed the anodized red or blue or black color
    • Alternately, you can try making your own spring out of coat-hanger wire. Just make sure to strip any coating off the coat-hanger first otherwise it won't be electrically conductive. Aover time, a spring made from coat-hanger wire may  loose its shape and may need to be re-lengthened.
  • Re-install the spring upside-down without extra bulb.
  • Fit li-ion cells into the adapters and assemble the flashlight.
  • If there is not good electrical contact inside, invert the adapter closest to the end-cap to change the fitment against the spring.

Selecting batteries and LED bulb

My 2D Maglite flashlight is long enough to accept two protected 18650 cells.  Instead of using the original incandescent bulb which would quickly burn out with more than double the voltage, I used a 6V-24V P13.5S 3W LED. This style LED seems to be more robust than LEDs designed exclusively for 3V usage.

Printing

PLA, PETG, whatever settings you want. If you print with lightning or zero internal infill, you can pause the print and fill with lead shot or sand if you want more weight to treat your maglite as a bludgeon.

CAD

To re-create in your own CAD package, its just a 63.5mm tall hollow tube with 34mm OD and either 18.75mm or 26.75mm ID

Tags