1 / 5
K8200/3Drag End Stops upgrade
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Better end stops for K8200/3Drag X and Y axis.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 16
- Makes
- 0
- Views
- 203
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
The end stops for X and Y axis are difficult to adjust as they tend to get loose when unscrewed.
The original two screw construction is complicated and I made this simpler "one screw" replacement for the axis.
There is no need for precise fine tuning of the X and Y end stops - I think this is a sufficient solution.
The original M4 screws can be reused or be replaced by shorter ones.
>> If you like it, please leave a like, rating or a tip... :)
Print Settings
- 0.20mm layer height, 15% infill
- 2 perimeters, 3 top and 2 bottom layers
- No support or elephant foot compensation needed