1 / 5
Drybox cap filler with hygrometer and PTFE tube connections — image 1
1 / 5

Drybox cap filler with hygrometer and PTFE tube connections

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Replaces the lid from sealed plastic cereal boxes to make a drybox with a hygrometer and PTFE tube connection - no cuts!

Rating
5 / 5
Likes
14
Downloads
100
Makes
1
Views
705
Reviews
1

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial — Share Alike

Part one of my single spool drybox prints.

Designed to work around these large dry food storage containers:

https://www.amazon.com/gp/product/B08TWH2QHV/

Replaces the original cap (which is easy to remove) with a blank that holds a hygrometer and has a pass-through for 1.75mm filament and 4mm PTFE tubing.

Prints quickly with no supports.

To install, twist the original lid cap and it'll pop off, then press this part into the hole. Designed to work with the original seal. Insert a round hygrometer - this is a generic design that is easy to find on Amazon - and then press in the end of a PTFE tube which is long enough to reach your printer. (For a Prusa MK* printer, this is about 500-650mm.)

A second short piece of PTFE can be pressed into the side hole to hold the PTFE cap when not in use.

For a spool holder, there are two options:
 

To cap the PTFE, use my PTFE tube cap with filament lock. Press in the filament, and it should wedge into place. The cap then can be slid back to the PTFE to keep it sealed, and when you need the filament, pulling out the cap will bring the filament with it.

Tags