IO-Mount Klicky Face Plate
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Face plate for the IO Mount toolhead to attach the original klicky probe.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 19
- Makes
- 1
- Views
- 381
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Remix of the face plate for IO-Mount toolhead to use with the regular klicky probe. Assembly is the same as the regular klicky's AB/SB mount. Then route the wires out the right hand side through the little opening and up into the toolhead with all the other wiring and to your control board. Use the official klicky probe itself. I am using the XL probe with my rapido hotend.
Also included is a super simple, no frills dock arm. Install a couple M3 (5mm OD x 4mm L) heat set inserts into the dock arm, attach the official klicky dock, then mount it to the front left of your printer near the stepper motor.
Because this printer essentially has no travel outside of the bed area, you will want to avoid printing all the way to the edge in that corner so you don't accidentally attach the probe while printing. Long term a servo based arm would serve as a better replacement.