LED Light for GALILEO Modular Microscope
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.17 – €0.20 net (excluding VAT)
For file: Top LED Holder_0.4n_0.2mm_PLA_MK4IS_12m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.19 excluding VAT (range midpoint).
- Weight reported by the author
- 2 g
- Print time reported by the author
- 12 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A bottom and top LED light to illuminate slides on the GALILEO Modular Microscope
- Rating
- 0 / 5
- Likes
- 29
- Downloads
- 78
- Makes
- 0
- Views
- 825
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Chemistry & Biology
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed this LED light to slide into the phone illumination module for the GALILEO Modular Microscope. All of the parts were printed in Hatchbox PLA with the exception of the strain relief grommet which is PETG. Note that the grommet will not fit unless it is printed at 69% in the X,Y directions and 100% Z direction. I tried to make the changes in the grommet CAD file but it blows up when reduced that far.
The slide switch is wired to change between the TOP light and the BOTTOM light. The LEDs in the parts list include a cable for USB charger and can be dimmed by holding the on/off button.
When tightening the screws for the TOP arm tighten just enough to prevent unwanted movement so it can be repositioned easily.
I think the rest can be seen in the photos.
Parts List:
- Slide Switch
- LEDs
- Double Sided Clear VHB Tape
- 22 AWG Wire
- (3) M3 x 22 SHCS (for TOP Light Arm)
- (3) M3 StopNuts
- (2) M3 x 12 SHCS (for switch)
- (2) M3 Nuts
- Small Piece of plastic milk carton cut to fit opening over BOTTOM LEDs as diffuser