1 / 6
Modular Enclosure Fume Filter — Swappable 28mm Cartridge (Carbon/HEPA) — image 1
1 / 6

Modular Enclosure Fume Filter — Swappable 28mm Cartridge (Carbon/HEPA)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Compact fume filter for 3D printer enclosures. Slide-out 28mm cartridge fits carbon, HEPA, or combined media.

Rating
0 / 5
Likes
7
Downloads
27
Makes
0
Views
557
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

This is a modular fume filter for 3D printer enclosures. It uses two sliding sub-assemblies — a centrifugal fan housing and a removable filter cartridge — so you can swap or replace the filter element without disassembling anything.

The filter box accepts any filter material up to 28 mm thick, which gives you flexibility: activated carbon pads, HEPA filters, HVAC furnace filter cutouts, or combinations of the two.

Bill of Materials

- Centrifugal fan 120×120×32 mm, 24V or 12V — [Aliexpress](https://www.aliexpress.us/item/3256805101944097.html) / [Amazon](https://www.amazon.com/dp/B08Q3Q2354)

- PWM speed controller (matching fan voltage) — optional but recommended for airflow tuning

- Filter media of your choice, up to 28 mm thick (activated carbon pad, HEPA, or combination)

- M4 screws and nuts — for fan mounting

- M3 screws and nuts — for rail assembly

- 12V or 24V power supply — matched to your fan

How It Works

Air is drawn into the fan housing through the inlet, forced through the filter cartridge, and exhausted out the other side. The filter cartridge slides in and out on printed rails — no tools needed for replacement. Pay attention to the rail orientation shown in the photos when assembling, as the rails are directional.

The filter can be mounted on top of an enclosure for recirculation, or ducted through an enclosure wall for single-pass exhaust, depending on your setup.

Print Settings

- Material: PETG (I used Polymaker PolyMax PETG)

- Nozzle: 0.4 mm

- Layer height: 0.2 mm

- Walls: 3–4 perimeters

- Infill: 20–30%

- Supports: only for the fan box (auto-generated by PrusaSlicer). Other parts print support-free.

ASA or ABS also work well and are preferable if your enclosure runs warm.

Why I Made This

I like keeping my filament stored inside the printer enclosure. Since I mostly print TPU, PETG, ASA, and PC, I needed a way to pull fumes out of the enclosure without creating enough airflow to warp prints or disturb the filament drying. This filter gives me just enough circulation to scrub the air while keeping the enclosure environment stable.

 

Tags