Zodiac/Dragonfly Dual Fan Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adjusted the height of the mount to account for the lower nozzle position.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 41
- Makes
- 0
- Views
- 683
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
Update: November 27, 2021 – I noticed that parts with tiny warped ends would scratch my mount, so I raised it up 0.6mm.
I made some small tweaks to allow this to work with the Zodiac hotend. By proxy this should also work with the Phaetus Dragonfly hotend, since the Zodiac is a direct variant of that.
Because the Zodiac hotend sits lower than the stock one from E3D, I lowered the mounts another 2mm so that the fans were not just blowing on the heat block.
I also realigned the upper and lower right mounting holes that screw into the extruder. When I imported the original stl and lined it up with the extruder part they seemed slightly askew. Functionally I don't think it is much of an issue as it is a very small skew, but I thought I might as well account for it in my remix.
WARNING: This will NOT work with the stock E3D hotend, as it sits lower than the nozzle and would crash into the bed. For a dual fan mount that works with the stock hotend, go here.