Radxa Rock Pi 4C+ Case (Smaller Version)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Improved case for the Radxa Rock Pi 4C+. Original by xjo26.
- Rating
- 4 / 5
- Likes
- 5
- Downloads
- 209
- Makes
- 2
- Views
- 1,099
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Improved version of my first case remix for this SBC. Enables you to put a dust filter fabric inside the case between the shell and the fan. Also added a heat insert variant.
Given the low height only low profile heatsinks (≤ 7mm) do work! If you need a case with support for bigger heatsinks please take a look at the linked one above.
You'll need the following parts for the heat insert variant:
- 4x M3 heat inserts (M3*4*5)
- 4x M3 screws, 25mm
- 4x M3 screws, 16mm (fan)
- 40x40x10mm 5V fan
- Dust filter fabric
For the hex nut case:
- 4x M3 Hex nuts
- 4x M3 screws, 35mm
- 4x M3 screws, 16mm (fan)
- 40x40x10mm 5V fan
- Dust filter fabric
Recommended settings:
- Material: PETG or ABS/ASA
- Wall thickness: 2mm (5 Perimeters)
- Top/Bottom thickness: 2mm
- Infill: None
- Support: Only for bottom.stl
- Adhesion: Skirt
Place the dust filter fabric between the inner case and the dust filter part, poke holes where the screws go and screw the fan in. It's a good idea to have the fabric slightly bigger than dustfilter.stl, that way it gets stretched out when screwing it down.
(Please don't mind the bad print quality in the photos, I was experimenting with new filament and higher speeds simultaneously 🙃)