Portable Drive Buddy - A no-solder USB-C 9mm Disc Drive case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Portable Drive Buddy is a sleek case for a 9mm disc drive, implementing a USB-C adapter, without any soldering.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 22
- Makes
- 0
- Views
- 223
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Open Community License v1.1 + General Attribution v1
Portable Drive Buddy v1.0
I wanted to create a (let's be honest) janky 9mm disc drive case that didn't require any soldering or custom parts and didn't have a cable sticking out of it. USB-C was the obvious way to go, so I used:
A typical SATA to USB cable
A USB-A to USB-C adapter
Ending with a USB-C female-to-female adapter
You can find all those parts on Amazon/Ebay/Aliexpress etc if you want to replicate this exact build, but you can also use differing parts. The only part that is fully implemented into the model is the USB-C female-to-female adapter, so make sure to use that as an end point.
Some glue may be required for the USB-C female-to-female adapter, and you can use thin double-sided tape for attaching the drive itself to the base. As for the cover, it can be press fitted, but feel free to apply some side glue if you think it's needed.
Hope you like it and find it useful!
I used my drive's front bezel cover (the black plastic part), but you can also print one of your own, there are a bunch of models for those around.
Printed on an Ender 3 V3 SE, with Sunlu PLA+ at 215C