1 / 9
Double Sparkfun Qwiic Sensor/Dispay Mount for XRP Kit — image 1
1 / 9

Double Sparkfun Qwiic Sensor/Dispay Mount for XRP Kit

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Attach two Sparkfun sensors or displays to the XRP with this mounting tower and use extra Qwiic port

Rating
0 / 5
Likes
9
Downloads
25
Makes
0
Views
232
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution
XRP Sensor/Display Tower

Originally designed to mount Sparkfun Qwiic 1.3" OLED and the ENS160 Environmental Sensor, this mounting tower, can be adapted to any standard sized Sparkfun Qwiic sensor and/or display. The mounting tower snaps into the XRP frame.

Imagine the XRP robot that can monitor and display (on the OLED) VOC, CO2, Temperature and Relative Humidity.  Students could program it to seek out the areas with the worst air quality or higher temperature.

The thickness of the tower is 10mm which can house 4-40, 3/8" standoffs screwed in from both sides.  Weighs under 9g (w/o sensors and mounting hardware).

The mount is designed to be able to be twisted around (mindful of the Qwiic cables) so the display can be visible in a particular direction.

Included are the basic CAD models with decals of the two components mentioned above for others to play around with.  Remember that the components, such as the Qwiic ports, stick up from the front and back of the boards.

Printing Instructions

Designed to be printed upside down, the mount can be printed without supports.  The screw holes are teardrop shaped to print without supports.  15-20% Gyroid Infill and 3 walls recommended for screw holes. Depending on how good your bed adhesion is, you may want to enable a brim.  Takes just over an hour to print with normal settings on an Prusa Original i3MK3S.
 

Bill of Materials (BOM):
Assembly Instructions
  1. Screw in the standoffs into the sensor mount (use the outer most holes for the OLED and the inner set for most Sparkfun sensors).
  2. Attach OLED to standoffs with screws.
  3. Attach ENS160 to other set of standoffs with screws.
  4. Connect Qwiic cable between these two cards.
  5. Connect 2nd Qwiic cable to the XRP Extra connector.

Tags