Meta Quest 3 Headphone Cable Winder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cable winder that shortens the length of your headphones while playing games.
- Rating
- 0 / 5
- Likes
- 21
- Downloads
- 113
- Makes
- 1
- Views
- 694
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- GNU General Public License v2.0
I recently purchased a nice pair of IEMs for when I was playing beat saber. I quickly found myself annoyed by the long chord, as such, I set it out to make a small cable winder that could attach to the Quest 3 and allow me to easily shorten the length of the cable and ensure that it would stay in place.
When attaching the winder to your Quest headset, I recommend that you place it over the strap and then slide it over the hard plastic, as it may be too tight to fit over it otherwise. One corner has a small divot, this is made to ensure that the microphone / speaker array is not covered.
You can use double-sided Velcro strips (10mm) to tighten the wire to lock it into place
Printing instruction
I recommend you print it with something like PETG, as it's a little less rigid, and allows it to flex when attaching. It requires two supports for the winding part, as can be seen here:
Make sure to orient the divot upwards when placing it on the build plate.