Magnet holder for centerlock disc brake[Check V2 instead]
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holder to attach a magnet on a centerlock rotor
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 32
- Makes
- 0
- Views
- 216
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
My new bike has centerlock rotors, so I designed this to hold a magnet for a speed sensor as I did not want to attach it to a spoke.
It uses and M4 x 8mm bolt and M4 heat insert 5mm deep.
I used a drop of superglue before pressing the 12x3mm magnet inside the magnet hole.
Printed in 0.3 with PCTG without supports.
Can easily flex to be inserted without removing the wheel or anything at all (use non-brutal material!).
Note the disc brake on the picture is a 180mm one. I assume it may work with other sizes too.
[Check V2 instead]
https://www.printables.com/model/1308259-magnet-holder-for-centerlock-disc-brake-v2
