Huina 1550 Upgraded Bucket Push Rods
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bucket push rods for your Huina 1550 This allows more angle of the bucket if used in addition to my other mod here :…
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 133
- Makes
- 0
- Views
- 1,105
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
Bucket push rods for your Huina 1550
This allows more angle of the bucket if used in addition to my other mod here : https://www.thingiverse.com/thing:3723652
Print one of each part except (2x) horizontal_v1
The cylinder_spacer is made to go in the middle of the vertical_v1 cutout so you can clip back your dummy cylinder into the now too small M3 bolt.
You will need :
- 1x M3x45 bolt
- 1x M3 nut
- Optional : 2x M3x6 washer head screws to use on the horizontal rods. Be carefull not to screw a long screw into your bucket gearbox inside there ! I prefer not to use them, the rods won't pop out by themselves anyway.
Bonus :
If you search for a "SRC012 Slip Ring" on your favorite online electronics retailer website (found mine on Ali for about 10$ CAD), you can have infinite rotation of the turret !
The Huina even has 3 plastic posts that perfectly fit the slip ring without any cutting !
You only need 2x M2.5 plastic screws to fix it
All you have to do is remove the white plastic limiter inside the turret ring gear, cut the track motor wires and solder them back on corresponding wires on the slip ring top and bottom.
Print instructions
Category: R/C Vehicles