Corne Collar
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a collar print for a wired Corne custom keyboard which uses the acrylic sandwich case.
- Rating
- 5 / 5
- Likes
- 17
- Downloads
- 60
- Makes
- 1
- Views
- 1,175
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
This is a specific case meant for use with the Corne acrylic sandwich cases, like here and here. Specifically, this has been tested with the 3mm acrylic plates from Keyhive. I am also using the PCB from Little Keyboards for this build. The goal was to provide a cover around the edges of the case while preserving the transparent nature of the bottom of the case and the top plate.
Hardware
If you are using the spacers provided in this print, a 1.6mm PCB, and 3mm acrylic, then the following should work for hardware.
- 10x M2 16mm screws
- 10x M2 nuts
Printing
Supports are needed for the inside tabs that hold the collar in place between the bottom acrylic plate and the pcb. I used the tree supports found in the latest iteration of Prusa/Orcaslicer.
0.2mm layer height will help the fillet on the top edge of the case look better than 0.3mm, but both work fine in testing.
You will need to print 10 top and bottom spacers as well .