Counting matching models…
This is a universal server rack ear fitting 20x20mm, 24x24mm, and 28x28mm bolt patterns. I based this off of the Linksys rack ear but made it a bit more universal since my Cisco Switch required a 28x28mm bolt pattern. I also made the 3…
This is meant to support a 1U or possibly even a 2U server. I've designed it to use M6 nuts and bolts and you can use 2 or 3 bolts per support. In total you'll need 4 of these (2 of which are mirrored) to support the server from all 4…
This is a rack ear meant for a Cisco SG300 series switch, specifically the SG350XG. The bolt pattern is 20-28mm squared (20,24,28 steps) so it's a bit more universal. I'll be posting a very similar one as a universal rack ear that's not…
Print Settings: Material: PETG (VoxelPLA Pro eventually failed after 3 years on my similar model) Walls: 3mm+ Top/Bottom: 1mm+ Infill: 40%+ I couldn't find a cheap set of rack ears for my linksys switch so I designed my own. The bolt…
I designed this to be quite sturdy so I could hold my coat and backpack which routinely weighs over 30 lbs. Print as solid as you can with a focus on more wall perimeters for maximum strength.
Material: PLA Pro/Plus or PETG Settings: Nozzle: 0.6mm Walls: 3 loops = ~2mm (1mm is plenty) Top/Bottom: 1mm (0.6mm is fine) Infill: 20% Rectilinear You don't need it anywhere near that sturdy though so ~1mm walls and .6mm top/bottom…
It fits a mini volt meter and a small rocker switch to check the voltage when needed. Since super caps don't have a lot of capacity I don't recommend leaving the voltmeter on all the time as it will deplete them within the day. I wanted…
I added a .2mm extrude on the very bottom to fill most of the ventilation and handle holes to make it a lot easier to print. You can just pop out the thin layer when it's done printing. Thje slots in the side are meant for clear 1.75mm…
I made this to have a convenient place to put my phone and galaxy buds in and wirelessly charge it. I also added a holder for an apple USB C power brick so my wife and I can both use it without losing cords behind the bed.
This is a reupload of my model from Thingiverse https://www.thingiverse.com/thing:2141412 . Initially designed to fit on my very small build plate of 175x175mm on my old Q3D ThreeUp printer. Bolt tabs were added to allow for easier…
These are all currently available results.
