Counting matching models…
NO software modification are required if you have a K1C Just print, glue up the original silicone brush and screw the bracket in place reusing the 2 carriage screws. Now you can use whatever plate you want. I have included a brush mold…
The camera on my k1c was not perfectly centered so I redesigned the bracket with an angle of 10 degrees. It replaces the original one, just unmount the whole camera (1 screw) disassembly and replace the original bracket with printed one…
Basic Bowden tube guiding system designed for filament feeding from the left side of the Creality K1/K1C printer. Required components: 2 pieces of M3x8mm screws (4 if u have K1) 2 Quick Fitting Connectors (M6/M10) Reuse the two tiny black…
The original round feet i really don't like and don't match the design of the printer in my opinion, so I redesigned them. My design shapes are inspired by the chassis frame. Also the foot is a bit lower than the original so it gives more…
The original washer is too low and loose + head screw housing in the chain cable is to large. So the cable chain is not firmly in piece one the toolhead, and it wobble when printing. This simple mod fix this issue, also helped me…
I had a little crack in this piece, so the gears where loosing and couldn't grip the filament. I printed with PC-PBT, 4 walls and 40% infill. Orientation like below, use supports for the inner part.
Removing the spring can be a solution to resonance issue but: if you remove them, the bearing on which they were acting is free to slide left and right a tiny bit before being locked by these two screws: credits to @Henlor for the…
Just a 3D model that you can print by yourself (Using TPU i guess) of stock K1C's rubber foott.
If you own a creality K1 series printer you know for sure about x axis resonance issue and you know about the springs trick. Someone obtained results removing completely the springs, some others by replacing them with weaker. So i…
I was always struggling when screwing/unscrewing something with one hand only, this helped me a lot, hope the same for you! You can swap the top part to fit different size of wrenches using the same bottom part.
I designed this tool based on the measurements of a Shimano Pressfit SM-BB71-41B. It might also work for other models, but I recommend checking the dimensions and making adjustments if needed. You will need few hardware parts: 1x This…
I needed a cover for the GCW02 tank to prevents solvent evaporating so i designed a simple one, fits well but obviously it is not watertight, maybe this can be achived by renforcing the model and printing a TPU gasket. I will try and…
This is a tool designed to help unscrew tank knobs without hurting your fingers!
These are all currently available results.
