Counting matching models…
Car stand to work on your RC Car in the pits or have it on display. The car tand can be disassembled so it can take up less space in your pit bag. There are 2 options for the side brackets with and without magnets, the magnet option I…
RC generic body posts, 4 different lengths, 8mm diameter (quite large), fairly sturdy. The title sums it up mostly. 92mm, 76mm, 55mm and 45mm, should be generic enough to use anywhere where the body post doesn't have to slot into any…
Nothing special required to print, prints flat on the plate with no supports. 0.3mm layer height 20% infill is more than enough. Use any solid/hard plastic and pic a complementary color to match your Car/ESC/Fan
This is a case you can use to put the RadioLink R4FGM receiver into. It just requires that you cut them free from the heatshrink which they come with. Puting them in a case makes it easier to handle in RC cars which are designed around…
This is a tyre washer used to clean up the tyres when you come off the track after a run and can just drop in a tyre in the washer and spin it up using a cordless drill while it's still attached to the car, repeat for each corner. Once…
These are just some dummy/vanity wheels you can put on your drag chassis to make it look/sit semi realistically on the shelf while not being used, rather then have your race rubber tyres or sticky, smelly old rubber tyres sitting on the…
This is a basic traction additive bottle holder that can hold 3 additive bottles on your pit bench to make it a bit more difficult to tip over as well as when you get back to base you can hang it up on the tool wall out of the way ready…
This is a handy little tray designed to hold all the different parts of a 1/10th scale RC Motor while you're working on, it holds the rotor in position and helps to spread the parts out so they don't all just get magnetised to the rotor.…
Some quick magnet holders to hold RC drift bodies on to chassis with magnets nothing flash but helps retain the body when you clip the track barriers side ways. 2 versions V2 has slightly deaper edges to retain the body better. Can be…
I just needed something for the office to keep some Costco Green Tea bags in rather then strewn about the drawer or desktop and didn't want to just have a nondiscript black box. This was a quick test print might try it in the…
This model is to allow 2x E 16-x sized Estes rockets to be mounted to an FS Racing 1/7th scale GT RC car. The ignition system is designed to replace the handbrake feature of the car, so instead of the servo activating the handbrake if…
Mount plate to mount esc on rear difuser with wiring underneath right rear out drive. This mount allows you to run the power, motor, esc signal and sensor wiring underneath a place and underneath the right rear out drive on the YD2SX3…
This is a bumper for the Proline 1/10 Chevy Nova No Prep RC body shell, it is contoured to support the front of the body and can be modified on the back end to suit your chassis.
These models were printed at 0.2mm layer height using Prusament PC Blend. You'll need to print the following: 1 x Front wing part 1 x Bumper Mount 1 x Endplate 1 x End Plate mirrored in the X direction The gurney flaps helps if you stand…
This is mount plugs into the back of the Byte Frost Ground Station (GS) unit where the battery would normally go and allows it to be clipped to the back of the Goggle strap such that you do not need to be tethered to a tripod. I built a Y…
Just a simple antenna mount for the Aerum Polar X receiver antenna. Double sided tape the mount to the goggles. Use nylon screws, zip ties or double sided tape to stick the antena to the mount. Even it you use screws or zip ties I'd still…
These are all currently available results.
