Counting matching models…
This is a flower vase that can normally be found on a mausoleum memorial wall or headstone at a cemetery. It is a drop-in vase that fits in an 80mm ring that is mounted to the wall/headstone. It was created as a less expensive option than…
This JB is a total of 48mm in height w/a 3/4" (19mm) side entry access hole, which allows use of the original Thingiverse JB Cable plug. JB also has a 5mm recess to allow the Reolink camera mounting plate to sit flush with the top of the…
This is a basic built to allow you to integrate an ESP32 device to monitor a "dumb" freezer and set alerts for any malfunctions before items inside the freezer spoil if they thaw by integrating into HomeAssistant via ESPHome. Wiring is…
This is a small basket is made with both 2mm and 3mm walls (chose your liking). Basket dimensions are approximately 92 mm bottom diameter, 130 mm top diameter, with a height of 140 mm. Volume holds ~ 1370 CC's (or 46 fl. oz or 3 pints/5.8…
This is a basic box to mount an ESP32 Max v1.0 Development board and four single MAX6675 modules (spi bus) that are compatible with K-Type thermocouples and a local display (i2c bus). The intent of this project was to be able to remotely…
This is a basic box to mount an ESP32 Max v1.0 Development board (Arduino UNO Clone) with a single channel 5V relay and a BMP280 temperature sensor (should work w/BME280 as well) to interface with a garage door opener utilizing a…
This is a re-mix of Microsoft LifeCam Mount by mproctor13 for use with the Articulating Raspberry Pi Camera Mount for Prusa MK3 and MK2. This works with the Microsoft LifeCam Cinema (720P) USB web cam. Major modification is that I needed…
This is a mounting plate for a HP Dual Port USB Graphics Adapter ( https://support.hp.com/us-en/document/c03606514 ). I created this primarily to address the fact that the micro-B USB plug would constantly come unplugged and can wiggle…
These are all currently available results.
