Counting matching models…
This is probably the easiest to print support for bent pipes and hoses. It's printable without supports. The slightly overarching design lets the hose/pipe snap into place. Holes for screws (3mm) make mounting to a wall or other flat…
This simple design allows the proper leveling of any piece of furniture with legs. Just print four sets of them and attach them to the base of each foot of, e.g., a table or shelf. Screw holes are available, but in most cases double sided…
Tighten a rope without knots. Fixed on a wall with four screws. Designed for a rope diameter of 5mm. Use this Onshape design to modify. Rope diameter and tolerance are parameterized. A STEP file is below. Update 2024/12/04: I added a…
This is a simple single cell 18650 battery holder. Two versions: vertical and horizontal. The difference is, where the contact flags for soldering come out. It has some extra tolerance for the spring. Modify it for your specific contacts.…
This protective case for a kindle ebook reader (11th generation) comes with a slim footprint. I designed it in a way that the hinges can easily be printed separately. The case is assembled by snapping on the hinges to the top and bottom…
I used the pick guard of my own 2012 MIM Fender Stratocaster to design this wiring jig. The pot and switch placement is accurate. Two tone, one volume pots and a 5 way switch find their place neatly on that jig. The pots and switch…
This is an ergonomic neckblock/support for maintenance on a electric guitar. I designed it for a Fender stratocaster (2012 MIM). The neck profile fits well until the fourth fret. The guitar will lay with a flat angle on a table with that…
This small project box is designed to hold a 18650 Battery and has a small compartment for a PCB. Mounting standoffs with holes (fit M2 screes) are included. The lid of the box slides open and snaps in place when closed. Dimensions:…
Can be used with 6.5mm (¼ inch) sockets. Printed in PETG with layer height of 0.2mm. Three walls with a 0.6mm nozzle, at least five with a 0.4mm nozzle. The socket key is exactly 6.5mm. Adjust your print settings (Shrinkage/expansion) for…
Updated! The design was created in Onshape and can be found here . There are several parameters that can be adjusted: tube diameter tube length tube wall thickness O-ring position and diameter of the profile O-ring size Explore and adjust…
Print settings (Orca Slicer 3mf included) 0.2mm layer height 5 perimeters for casing, spool, driving gear, both axles 3 perimeters for lever, shaft caps, handle and crank 20% or more infill For more stability use alternate extra wall Use…
The only part I basically remixed here is the LCD spacer. You will need M3 bolts and M3 threaded inserts. Threaded inserts are used for the back plane. the LCD spacer from both ends. Use the original LCD spacer if you don't want to use…
Introduction I was looking for a design of a center of gravity scale for small RC gliders without the need of much additional hardware and couldn't find any existing models that fit my criteria. So, out came the version you see here. It's…
I wanted to create a smooth action phone holder that uses a sliding mechanism. So, I created this one. Required Hardware 7 M3 threaded inserts 7 M3 bolts A few rubber bands Some foam pads (see title picture) Printing settings and…
Fits the hex shaft of the dimmer that can be bought here . The fly-wing nut inspired design makes it easy to rotate with one finger. STEP file is available. Onshape design here .
You'll need two 5x2mm magnets. A dab of super glue keeps them in place. Insert the strip and clip base and top together. Onshape design.
These are all currently available results.
