Counting matching models…
This is a small jewelry box which has the lid securely snap into place. It's quite small by default; I made a bunch at 1.5x scale. The original I derived it from has too round of a fillet at the bottom, so you may want to lower the model…
This variant of BibbEZ is far easier to print. Use uniform 0.2mm layer height with one wall and 100% infill. Selecting one wall is important for the bridging to work properly. If you're using Cura, also turn on “experimental bridge…
If the panel of your Gen 2 Prius liftgate has become dislodged, use these parts to provide reinforcement for the screw mounts. 1 and 4 reinforce the existing screw mounts. 2 and 3 go under the existing screw mounts but the screw sits down…
This is a lighter-weight replacement for the stock shroud on the KLP1 toolhead, that lets you use a standard form-factor 5015 blower fan (the OEM part has a larger port). I measured the stock shroud at 80.5 grams, and the replacement…
Overview This is an improved version of Olympia's smoother parametric gateplates with a thread holder optimized for FDM. The original was meant for resin printing but I find that resin gates feel less pleasant than FDM, as the stick…
Print from TPU; I used 95A. The original gave no advice for settings, but I found it worked well with 3 walls and 25% cubic infill. At first I printed it with 2 walls but the inner side wasn't rigid enough and got loose. Enable "Avoid…
This is not very secure and will not work with Arca-Swiss plates that have anti-slide-out stops. I only designed it to be better than simply balancing my audio recorder on my cello case in case it got bumped. Print it with 3-4 walls and a…
This is a novelty computer case for the Framework Laptop 12 that has the airflow come in through the trap, and has the flush lever act as a power button. Otherwise, it looks like a rather normal toilet, with a few extra grilles here and…
The 100 doesn't fully constrain the forward/aft bed tilt since it only has two leadscrews and the bearings are very far away. This mod adds a third motor and leadscrew at the front left to constrain this tipping. You need three…
I couldn't find an OEM one, so I replaced the filter on my Ryobi One+ shop vac with a Milwaukee one that fits fine, but it has a different bayonet mechanism and so it would randomly fall off, letting dust bypass the filter. Glue this ring…
My orchestra director's music stand isn't tall enough to support her new 11x17" scores, so I designed these to extend the top. It'll only work on metal stands that don't have rolled edges; the stand needs a solid top edge that is about…
Overview: This is a Bowden toolhead for the KLP1 210 that uses: Dragon ACE hotend, likely also Rapido/Rapido 2/Rapido ACE HF 4010 heatbreak fan (I use a Fabreeko Honeybadger) 5015 part cooling fan (I use a West3D Berserker Vindr) Beacon H…
These are all currently available results.
