Counting matching models…
Hot end clogs on the mini are attributed to heat creep and poor PFTE setup. I've managed to fix this issue by not installing a aftermarket heat break but by adding better heat paste and re-routing the hot end - thermister and heater…
50mm Fork Seal Hammer for seating your new fork seals for a Ducati Hypermotard 1100 Evo. Plenty of other bike models run these forks. 2 piece shell of the slide hammer is held in place by the 2 rotating collar lugs. This slide hammer can…
Crank case puller to get at that starter or alternator. Remember to drain the oil first and use a mallet to tap the case progressively as you increase tension. There are a few recesses on the case where you can lever the case with a screw…
Installed an all in one rear brake and indicator LED assembly. Last part was to clear up the rear tail now the indicators were removed. This print will allow you to just mount the number plate and light. Utilizing only the rear frame for…
Ducati Hypermotard 1100 Evo indicator adapters for any 8mm indicators. This will allow you to move to cheaper and more extensive range of mirrors for your Ducati. Once you move away from the limited integrated indicator and mirror…
My older van had no cup holders so I made a version to bring the van into the 21st century. The universal base plate can be attached securely to a flat surface out of the way of car controls and then the cup holder of your choice slides…
Wasn't thrilled with other offerings so had a crack myself at the AA box, this is the AAA version based off that initial design. AA version is here - https://www.prusaprinters.org/prints/75123-tiered-aa-battery-box Should have a bit more…
1 year old loves buttons, had to cover it up to prevent inadvertent power on or shut down. This should fit the Fractal Design Define R5 or similar cases with a small step on the front. Hole size is 2mm, M2 countersunk head should work…
Rear plate for your Toyota Hi-Ace or other 2RE motor. Mine rusted though and had a pin hole leak, will result in a leak around the right hand side of the transmission body. Toyota sell them for <$20 but are often 4 weeks out so this will…
Had my eves removed during a renovation and wanted to temp install the cameras for a few months on 40mm timber braces until they were re-fitted. Press fit M4 hex nut's with a vice directly into the print (no glue needed) and bring your…
These are all currently available results.
