Counting matching models…
a light stand that is attached to one pedal and only holding the bike by tilting against the pedal. the pictured version is printed with PLA with 30% infill and 2 perimeters and up to now its working, but for long term use i recommend…
I encountered regularly the annoying problem that i had to disconnect the MMU3 from the extruder and connect an other PTFE tube to use the printer without MMU3. now i do not have to do that anymore :) most of the other connectors are…
simple handlebar stabilizer max supported diameter of the handlebar 40mm max supported width of the main bar 50mm i recommend to add a thin layer of rubber at the position of the main bar in order to prevent damaging the surface of the…
i was not able to purchase the official vertical GPU mount from corsair as they have an annoying error on their homepage. after contacting support they concluded that this holder cannot be shipped to my location ….. yeah…i dont think so.…
this connector is useless unless its added to an own design. the attached stl file can be used to makes some testprints to find the optimal printing alignment and scaling corrections. for me both alignments (connector on heatbed and…
IMORTANT NOTICE: This design is completely made by me, it may not fit to original buyed variants. Parts to be printed (15% infill): 1x Body 1x Hammer 6x Leg 43x Block What you additionally needs: a figure or other toy that serves as a…
see the pictures for some ideas what to mount to the bow. the clamp should be printed with a flexible material in order to not damage the surface of the bow. the profile of the railadapter is compatible to the decathlon sight rails (club…
I encountered the problem that in the months with temperatures < 0°C my rear brake bowden cable freezed because there was water in the bowden cable. unfortunately this brake is designed in a way that in horizontal mounting position (as…
a penholder for people who are into math
easy to print and click on repair. if you adapt the size with test prints you can do it without the tape (like i did) you need the to print the "Koss_GMR545-air_Repair" 2x times. i also added the fusion archive and step file if you want…
These are all currently available results.
