Counting matching models…
You will need six 18x12x4mm bearings, M3x12 screws, M3 nuts and two M4x16 screws and two M4 Nuts. I recommend to use 8mm aluminium hex rod to make the axle, instead of the printed hex rod. The rims get screwed together by tiny 2x10mm wood…
https://youtu.be/aHf-W1n8ITU?si=BQhXFbC39kVWgMhv Check out my profile for the rear axle and all the other parts. -You will need M3 Nuts and Screws in 10, 12, 16, 20, 25, 30 and two in 55mm lenghts. -12x18x4mm bearings. (Just buy 20 or so,…
Update 16.5.2026: new front shock mount, upper control arms and added belt tensioner All parts can be printed in PLA. I recommend printing the small 12T motor gear in PC, as it might melt in PLA when the motor gets warm. I never managed…
UPDATE 16.10.2024: added updated Halbmond and Kreuz with thighter tolerances
The moss should grow outside the grid after a while. I will update the pictures in a couple of weeks.
You will need 300g of filament, 12 hours of print time, an M5 nut and M5x25 countersunk bolt and a 42x30x7mm ball bearing. Please enable "External perimeters first"…
A updated, better looking rear suspension for the Trophy Truck V4. It also is more sturdy and saves 50g of weight.
I made fully printable and rock solid extrusion profiles.I made fully printable and rock solid extrusion profiles in 25x25mm for M4 hardware. The profiles can be scaled up by 120% to be used for M5 hardware in 30x30mm. The standard lenght…
This is a 3D printed shock absorber I made for a future 1:5 scale RC car. the travel is about 40mm. It uses mineral oil (baby oil) as a working fluid and uses a M6x80 bolt with the head cut of and threads cut on the secound end as the…
You will need three Spannhülsen, the rest should explain itself. It will clamp strongly on a regular 25mm PVC Pipe by tightening the screw and hold two standard E27 sockets. It might also work on slightly smaller tubes.
Replacement part for the Ikea Forsa lamp. Works fine in PLA with a LED bulb which stays cool. You will need to drill out the rivets on the old plastic part and replace them with two M4x10 cylinderhead screws. For the clamping mechanism,…
I made a model for the rod end of the shock absorber, because the part was not available at the time. Its a quick fix, but obviously not as good as the real part. The real part can be found under the number ARA-1495
You can reuse both panhard bars as upper links for the front axle. You will need another 117mm bar for the rear, or depending on what ball joints you use, you will need the 64mm links for the front and 124mm links for the rear. I have…
The rims get screwed together by tiny 2x10mm wood screws. The tires used are General Grabber X3 4.65x1.75-1.9 The wheels will fit nicely under the wheel wells with nothing sticking out, if you do the 4 link conversion.
These are all currently available results.
