Counting matching models…
This model just contains additional height modifiers (and a scaled Z axis to height 60 mm) in 4 mm steps (15 steps total) to allow testing a lot of flow rates. To use, chose a layer width and layer height (I have a 0.6 mm nozzle, so I…
Description As part of my Ender 5 enclosure to be used for printing ASA, I designed and printed this air filter that takes an off-the-shelf Ikea Förnuftig active charcoal filter and runs with 2 140 mm fans. The overall filter is 76 mm…
This remix fits the shotglasses I found in my local grocery store (see attached image). The shot glasses are glued down some transparent silicon (which should also make them removable if some cleaning is required). To clean, take care to…
A quick remix to use the nice adapter design for the Ender 5 Y axis linear rails, to mount it with M3x8 socket head hex.
This replaces the stock electronics cover and allows running a 80 mm + 140 mm cooling fans, which achieve better cooling at much lower noise compared to stock. The two part design also allows accessing the low voltage electronics (left)…
This is an adapter that fits onto the standoffs on an E5 pixie enclosure box, and allow snap-in mounting of a Fysetc Spider board. It has cable guides: e.g. endstops and such can be run on the left side below the guide power in and bed…
This mount is to get the best possible data for resonance testing for Klipper's input shaping. It is designed specifically for the Dragonfly BMS heatblock, as it uses the threads for the heater and thermistor grub screws. Note that there…
Inspired by [king chess piece from Creative-Prints](https://www.printables.com/model/582262-kingkonig-chess) (partially traced the original model for proportions), this is a king chess piece to use as the control stick attachment of…
This design is a remix of Juan Callon's really cool belt tensioner design (I remixed so that each belt end has it's own clamp, which may make it a bit easier with tightening and less likely to slip) - mounted onto the BMG V6 MGN12H direct…
Uses two heat inserts and 3 3 mm nuts to mount an Annex Carabiner PCB to a Creality motor mount (40x40 holes) onto a 2020 aluminium extrusion, such as an Ender 5 frame.
This is a mount (marked yellow in images) for an Annex Engineering Carabiner to mount onto a Creality (Ender 5) hotend. The mount uses mounting holes of the Manta MK2 Rear_Mounting_Plate_E5 (credit to BoothyBoothy, blue in images), as…
These are all currently available results.
