Counting matching models…
I can't get a construction pencil to stay behind my ear so I used to jam it between my hat and skull but that had inconsistent staying power. Consequently, I drew this clip up years ago on paper and now having a printer decided to convert…
There are other flaps available but the ones I clicked on only gave model numbers of vent they were designed for. No idea what the model of this vent assembly is but the louver this replaces measures approx: 1.25" W x 4.75" L, 0.25" D.…
I was asked to make this and didn't consider looking on Amazon or Printables first; however, since I completed it I figured I'd chuck it up here. Amazon sells sets of these for like $15 and there is a model on Printables for just the…
Full body protective case for the USB FM transmitter module sold on Amazon. I've included several options for tops and bottoms. One top is specifically designed to be printed with TPU for the effect of being able push the buttons through…
The KSUN M6 is a great little PMR/FRS/GMRS/Ham walkie-talkie that can be used for short range UHF communications between 400-480Mhz with 0.5w on low power and 2w on high. If you want a full review, watch the video below, however, the main…
My father wanted to mount / couple this 4 11/16" vent fan to a 3" PVC pipe to draw fresh air into his basement so I made the following. For printing, I split the model as shown in the screenshot and glued the halves together using 8-32…
Replacement cap and spout for your run of the mill glass bottles used for olive oil etc. Printed using Creality 95A filament with good results. Cap is plenty tight just as the top starts to flex during closing. If you keep tightening…
Problem: All the caps that came with the 48oz glass bottles I was using for kombucha fermentation / storage had worn out and did not hold pressure any more. Solution: Kombucha Kaп! Cap works great on the bottles I tested it on (pictured)…
Sometimes it gets a little rowdy in the kombucha bar and order must be restored. It is no problem; break out the Kombucha Kaп Killer Karambit and all ne'er-do-wells will re-think their choices while sipping their beverages. Also, stubborn…
My mother wanted her wind chimes hung up but my father didn't want to put any holes in the porch ceiling. Having a 3D printer, naturally I devised something to keep the peace. The first one I printed entirely out of PLA and it works fine…
I made this case for the ATS Mini V4 metal as a Christmas gift and had a devil of a time printing it properly due to the heating system being broken all winter. I've finally got it to where I'm happy with it enough to share. A few things…
These are all currently available results.
