Counting matching models…
Print 2 holder for 1 rail. layer height: 0,2 mm perimeters: 2 infill: 15% (gyroid pattern) Depending on the rail itself, it can bi difficult to insert it into slot on holder. Some rails are slightly bent. Length of rail can be custom. In…
Print settings: layer height: 0,2 mm perimeters: 2 infill: 15% (gyroid pattern) There are 2 clip sizes. One is normal and one is thick. Thick clip is meant if you want to move clip all the way to the holder. In that case, the attachment…
Compass for riichi mahjong. Slot is for standard scoring sticks (65 x 7 x 4 mm). Tiles on the picture are AMOS 28 mm (28 x 21 x 16.5 mm). You can make compass bigger or smaller depending on tiles you are using. Compass size is 130 x 130 x…
I recommend you print left and right part, even if you need only one replacement. Reason is that these parts are not 100% same size as originals. If you leave one original part, keyboard might not be levelled. Print settings: 0,1 or 0,12…
Template for katakana. Size is for technical pencil 0,5mm. You can increase or decrease scale, but note that smaller scale may lead to too small holes for the pencil. If you have fine tuned printer and fine nozzle I think it is possible.…
This case fits 10 608ZZ bearings. 3mf file already includes modifiers for speed and quality. Layer height on tube is 0,24 mm, on thread it's reduced to 0,12 mm. After print, try screwing the lid on few times and clean the case before…
Can be used on various Arduino and STM Nucleo boards: Arduino Zero Arduino Uno Arduino Due Arduino Leonardo Arduino Mega STM32 Nucleo64 boards It can be used on any board that has the same hole position as Arduino Uno board. One example…
Attachment for Jetson Nano 2GB. Print settings: layer height: 0,2 mm perimeters: 2 infill: 15% (gyroid pattern) Additional material You will need 3 M3 x 15 (or M3 x 16) screws and 3 M3 hex nuts to attach development board to the…
Bottom plate attachment for Analog Discovery 2. Print settings: layer height: 0,2 mm perimeters: 2 infill: 15% (gyroid pattern) Additional material You will need 2 M3 x 6 screws to attach the device to the attachment. For DIN rail clip…
This case fits 10 F695 bearings. 3mf file already includes modifiers for speed and quality. Layer height on tube is 0,24 mm, on thread it's reduced to 0,12 mm. After print, try screwing the lid on few times and clean the case before…
A fun mind puzzle. Try and solve it without a help. If help will be needed, I will update the model and add a manual how to solve it.
A fun mind puzzle. Try and solve it without a help. If help will be needed, I will update the model and add a manual how to solve it.
A fun mind puzzle. Try and solve it without a help. If help will be needed, I will update the model and add a manual how to solve it.
These are all currently available results.
