Counting matching models…
The mesh lid on my 10 gallon terrarium was too ventilated and rusted from keeping it in high humidity. This has far fewer holes (while keeping some for ventilation) and I printed it from ABS and PETG (ABS warped far less than my PETG…
Nothing additional to say...
The teeth on the right cam in our kit arrived damaged. Crunchlabs is sending a replacement part for free but I took this as an opportunity to practice replication design in fusion. Note this is the right cam only and it's not 100% perfect…
I replaced my old ballast lights with simple low profile LED ones and needed smaller cans for the shorter wiring. Use PCTG, ABS, PETG or some other heat tolerant material since it can get quite hot in attics and light fixtures. Also…
Basic straw/silverware/pencil/whatever holder with a touch of whismy. Lots of ventilation and drainage and a curved floor to direct liquid down the drain holes. Daisy is printed separately for best chance of success and potential color…
I had an old bed frame that had a lot of wooden slats (~4.5mm thick) that I didn't want to throw out so I made these simple clips to hold the wood in a rectangle form to make a stacked planter bed. If you need them a different size you…
Strongly recommend TPU-95A as it has a good amount of flex without tearing/snapping easily. Supports: On build plate only (Snug, 0.2mm top/bottom distance, 1 top layer, 2 bottom layers) 25% infill (Gyroid) 0.2mm layer height (Strong…
Replacement posts for Kids First Intro to Gears set. I printed at an angle with ABS (see photos). These were pretty difficult to print at an angle but I couldn't find a better way to get the posts to print fairly cleanly. Supports around…
These are all currently available results.
