Counting matching models…
None of the current models in this space quite met what I was looking for. I printed one and the model didn't actually fit, there wasn't a STEP source so I just decided to make some either to serve as a base or to use. I have printed and…
I had printed out the original, but the F695 bearing i had was really loose in the arm. I adjusted the bearing tolerance to be 13mm even down from 13.3mm. This seemed to let the bearing I have pop in gently and fit snug. Let me know if…
I made this for a Dyson V11, but i would imagine it would fit other handheld vacuums of theirs. I did try it on one of their floor vacuums that we also have and it did not fit but was close. The vacuum attachment this was designed to fit…
This PCB mount was very close to working, but just was missing the last little bit to make it work well. The cable LDO provides is a bit chonky, so this extends the length of the cable support and better accommodates the overmolded end.…
BOM 2x 18mm standoffs 2x 20mm standoffs 4x voron spec m3 heatset 6x bolts 2x 1/8" zip ties Print on back. Print it strong, don't skimp. Voron or monolith settings. On the sherpa side, just add 2-4mm to the bolts so they stick out the back…
My take on fitting an ECAS collet on the Sherpa Mini (R2 Rev1). The others available on here had weird slicing artifacts, holes in the STEP/walls too thin, or stuck out from the top & had a filament sensor. I didn't want any of those…
Lens cap for a common keychain/toy camera. I had trouble finding a definitive name, but its usually sold under VETEK brand. I found mine under the brand FLATIC. Here are a few amazon example listings (not affiliate links):…
Ducting for the bed fans and some catchers for junk falling off the bed. Print one of each duct and deflector. The right duct will require support. The deflectors will require support for the tabs that go in the extrusion. Everything…
Replacement feet for the Jonsbo N6 NAS case that help reduce noise transfer. I printed in 95a TPU, 2 walls, 5 top/bottom, 10% cross hatch and they a good consistency for my setup (6 HDDs populated). I would recommend a 1mm bottom surface…
A modified version of Kyles purge bucket, designed to accommodate a brass brush. It was a great mod, I just prefer a brass brush for those hard to clean filaments. I did my best to preserve the original aesthetic. Note that the height of…
These are all currently available results.
