Counting matching models…
As part of setting up your Brompton folding bike for a ride you need to set the saddle position every time. A saddle height insert (one ships with the bike) allows you to fix the saddle height so it is in the correct place every time you…
I have several blinds around the house that use the Eve Motionblinds upgrade motor. My issue is that for the 38mm tube, especially the single slot version, positioning the motor centrally in the tube can be hit and miss. The motor itself…
The excellent Unifi G6 Instant camera, out of the box, sits flat on a surface or can be fixed perpendicular to a wall with an included mount. My immediate need was to have a shelf stand so the camera could be tilted rather than sit flat…
This simple to print holder is designed to accommodate the set of ImpressArt 3mm Alphabet stamps. This is 26 letters plus one “&” stamp. The holder is sized for 28 stamps in total which are physically 6.25mm square in the shaft and 3mm at…
I had an old set of towel hooks that were aligned vertically to fit on a slim strip of wall in the kitchen. However, their design, using rubber grips, meant that after a few years they weakened and the towels fall out. I therefore made a…
I had built myself a KiwiCleaner watch parts cleaning machine. The KiwiCleaner design has a sealed PSU fitted to the underside of its baseboard. The PSU has a very short mains cable that cannot be safely replaced with a longer one. I…
This is a mount angled at 45º for a Ubiquiti Unifi G4 Doorbell Pro. I have included a modified left and right hand version. My doorbell operates via a USB-C cable linked to an ethernet to POE adaptor. There is just enough room within the…
I liked, very much, the original lamp stand with outer thread to hold interchangeable lithophane planet lights, but had some qualms over the lack of a cable cover and particularly a cable clamp. Hence this version which addresses both of…
This lamp shade is designed to fit an LED GU10 Lamp base which can be found here . This base has a screw thread imprinted to secure the shade and the shade here has the matching thread. The shade model allows for a colour change. i.e. I…
This lamp shade is designed to fit an LED GU10 Lamp base which can be found here . This base has a screw thread imprinted to secure the shade and the shade here has the matching thread. The shade model allows for a colour change. i.e. I…
This lamp shade is designed to fit an LED GU10 Lamp base which can be found here . This base has a screw thread imprinted to secure the shade and the shade here has the matching thread. The shade model allows for a colour change. i.e. I…
My wife makes jewellery and asked for a stand to hold silver solder paste syringes. There are four grades labelled: Easy-easy, Easy, Medium and Hard. This rack caters for 3cc syringes with a 12mm barrel diameter. There are two versions of…
I was looking to replace some LIFX LED ceiling lights. They had required quite a large hole in the ceiling of 90mm diameter. My replacement lights (Collingwood H2 Pro 550) were simply too small for this sized hole - hence this solution.…
This lamp shade is designed to fit an LED GU10 Lamp base which can be found here . This base has a screw thread imprinted to secure the shade and the shade here has the matching thread. The shade model allows for a colour change. i.e. I…
In fitting a Unifi G6 Turret camera to the wall, I discovered that the view angle required was just beyond the camera's physical side-to-side adjustment. Not finding a wedge mount to provide the increased tilt I designed this one. The…
I made a thread mesh monitor and part of it uses a Seeed Studio Xiao MG24 running the OpenThread RCP (“radio co-processor”) firmware. The issue I have is that the MG24 circuit board is vulnerable to being short-circuited against anything…
These are all currently available results.
