P
PrintablesAW
USBC PD Trigger case
This is a case for generic PD trigger modules I found on Aliexpress. The rough length is 11mm. No support is needed but I had to clean up the oval opening a bit to make it fit.
- Downloads
- 127
- Likes
- 30
- Rating
- 0
All models
Counting matching models…
P
PrintablesAW
Daily Task Reminder
No support needed. Print the base then scale the face plate to make sure it fits. My printer likes to make inner dimensions 99.4% of the original size so I scaled down the face to fit. The day ring is a bit loose but is sufficient. Darken…
- Downloads
- 125
- Likes
- 40
- Rating
- 4
P
PrintablesAW
Wyze Pan Wall Mount 45 deg
There are many wall mounts for the Wyze Cam Pan, I just needed one that was angled so I can mount it high and see the whole room. It has a relatively small hanging hole, I hung mine on a finishing nail. You will need a 1/4" nut and bolt…
- Downloads
- 62
- Likes
- 14
- Rating
- 0
P
PrintablesAW
Lighted Tactile Button
This is a small momentary button about 26mm square with space for a single addressable LED. All three pieces print in approximately one hour. Print button with flange facing the build plate, I used support and left it in there. Original…
- Downloads
- 26
- Likes
- 2
- Rating
- 0
P
PrintablesAW
Generic SFP Media Converter Case
No support needed, just have it print on the faces. Will fit together. I have already added a 0.1mm space to the cover so it most likely will not need horizontal expansion to fit.
- Downloads
- 24
- Likes
- 0
- Rating
- 0
P
PrintablesAW
Daiso 5.5L Spool Holder
Designed around the Daiso 5.5L food storage box and the 608zz bearings. This uses 1" pan head #8 screws (11mm head, 4mm diameter at the threads) to hold the bearings in place and provide additional support. It is held to the sides with…
- Downloads
- 17
- Likes
- 4
- Rating
- 0
P
PrintablesAW
Dyson V6 Motorhead Cap
I was reviving a old Dyson V6 that was missing the cap and shaft to hold the brush in place. As you can see from the picture it is V6 variant that has the lower profile head/brush unit. You will need a standard bearing to couple the…
- Downloads
- 16
- Likes
- 1
- Rating
- 0
P
PrintablesAW
Door sensor tilt mod 433mhz
Inspired by the Wyze Garage Door Bracket. Really great idea scrolled by it several times thinking it had to fit over a hinge when all it needed was gravity. This is made to fit the 433mhz door sensor GS-WDS07…
- Downloads
- 9
- Likes
- 0
- Rating
- 0
These are all currently available results.