Counting matching models…
The distance between the screw holes is 80 mm. Screws should be 3,5 - 4 mm in width. FreeCAD file is included for customization. According to comments it fits some 18 V models like the XLC11 as well. Print info Filament: Generic PLA…
This is a mount for the BTT HDMI7 for the Voron 2.4. It provides clearance for a clicky clacky door. This is only the mount to the 2020 extrusions (the black part in the photos), I'm using it together with the display case from Jon H…
A variant of my 18650 case (https://www.printables.com/model/554019-18650-battery-carry-case). It fits common AA batteries and unprotected 14500 Li-Ion. Closes tight and doesn't roll off the table. Body prints without supports. Lid needs…
This compact bit holder is convenient if you need to carry both sizes in a tool bag. The base and the lid are held together by cylindrical magnets and the lid can be used to collect screws while you work. I included some variants as…
This mount fits a “Camp4 Camping-Duschset mit Akku-Tauchpumpe” (Camp4 camping-shower-set with battery powered submersible pump). The mount this comes with is garbage, so a replacement was necessary. This will probably not fit other models…
This ring holds eight 5 mm white LEDs and is held in place by four cylindrical magnets (4 mm diameter, 6 mm length). It is placed around the hole between the rear compartment (that holds the laser tube) and the front compartment (that…
A set of watch hands in the style, that is typically found on a "Schwarzwälder Lackschild-Uhr" (https://de.wikipedia.org/wiki/Lackschild-Uhr). The minute hand is ~108 mm long, the hour hand is ~82 mm long. The mounting holes are 2.2 x 2.2…
This is a jig that holds a chisel at the correct angle while sharpening with a whetstone. It uses common 608 bearings as rollers. Features: printed angle adjustment wedges 25 - 30° rollers left, right and center enable you to use the…
I needed the bowden retainer at an angle for my top mounted spool holder. Tolerances work for ASA and default Voron parts settings (4 perimeter, 40 % infill, 0.2 mm layer). Use one M3x8 SHCS or BHCS screw and one M3 hammerhead nut (same…
English below. Dieser Winkelanschlag passt auf Metabo Führungsschienen für Kreissägen und harmoniert gut mit der kurzen FS 80. Auf diese Länge halte ich ihn für ausreichend genau. Mit dem blauen 30 cm Winkel (siehe Fotos) habe ich…
The small variant fits a 250 ml “Intense Repair CICA Bodybalsam” bottle (~ 66.7 x 35.5 mm). The large variant fits a 400 ml “Deep Moisture Bodylotion Sensitive” bottle (~ 76.7 x 44 mm). FreeCAD files are included for customization. Print…
These are all currently available results.
