Counting matching models…
Trimmed as much width as possible and reversed the side the riser mounts onto to gain even more space. It now takes up less space than the riser cable itself. Supports are now needed against the riser mounting area. I'm using this bracket…
Requires a pair of M3 screws to assemble. (Use at least 16mm length, but longer lengths should be fine.) A single M4 or M5 screw + T slot nut can be used to hold it to the extrusion, but this probably isn't necessary if you don't expect…
Hardware: Two M2 x 6mm screws Some cables and connectors to wire up the LEDs (I used dupont connectors and an angled pin connector soldered to the LED stick.) Adafruit NeoPixel stick Software: Klipper LED Effect (Syntax for configuring to…
This is a set of mounts I designed for mounting the E3D Hemera to my HyperCube build. The blower fan and probe mounts should be compatible with any other printer if you'd like to mix it with another carriage design. Included parts: 12mm…
I designed this for printing using a multi-material capable printer, but you may be able to print it using manual filament swaps. The backing has a slot for pressing a safety pin into. I used a 3D pen to “seal” the safety pin in.
"Spikes" to deter cats from standing on the edge of glass tabletops, e.g. a TV stand where they then paw and jump at the TV from. Prints on its side with zero supports.
The stock bracket thing that holds the bottom of the back panel onto the case is needlessly bulky, which made it impossible to route all the cables for my build. To be fair to Phanteks, this case does predate HDMI 2.1, whose cables seem…
Just a simple adapter I threw together to hold a particular kind of hand sanitizer bottle to my bike. Might mess around with making it parametric to fit different bottles and bike frames, if there's interest. Category: Tool Holders & Boxes
Multi-material Bernie 2020 pin! The pin backing is a separate part that can be deleted if you choose to print it as a card or enlarged placard. https://berniesanders.com/ Update: Oof. Print instructions Any blue, white, red, and…
Made this for my NZXT Havik CPU cooler. The fans were hanging loose off the heatsink due to the rubber bits holding them together drying out and crumbling. NZXT stopped making this model years ago, so they were no help in offering…
Note: This intended for the original HyperCube with a single Z-axis motor. It's probably not relevant to any HyperCube Evolved designs. This is a bracket for holding the bed to a 12mm smooth rod in a way that should hopefully reduce sag.…
Compatible with my 50mm fan mount and my 40mm fan mount . I designed it for use with this endoscope. Thanks to Teaching Tech and Chris Riley for the excellent guides on how to get it working Category: 3D Printer Extruders
Is it a good idea to mount such a heavy filament sensor to the top of a direct drive extruder? Probably not, but I did it anyways! The very minor benefit here is that slightly less filament is left over when a roll is finished. FWIW, I…
A door stop to discourage people from using our makerspace room for their work meetings. Update: It didn't work. Category: Office
The stock clamp/bracket/thing that holds the bottom of the back panel onto the case is needlessly bulky, which made it impossible to route all the cables for my build. To be fair to Phanteks, this case does predate HDMI 2.1, whose cables…
A stupid simple endoscope mount that clips on to 5015_Dual_Radial_Fans_Dual_Ducts.stl from Hero Me Gen5 Master Suite . Has holes for M2 screws to secure the endoscope's position. Category: 3D Printer Parts
These are all currently available results.
