Counting matching models…
This is a rework of my own model from thingiverse (from 2012). “cyclone to catch the spray while purging/cleaning an airbrush.” There may be some sputtering especially with airbrush nozzles bigger than 0.2mm. Prints without supports, a…
This is a very simple model. I did not find a buckle for cord with a release by pressing the sides. It prints without support, the cutouts will have a little bit issues without support, but just a little bit. The holes have a diameter of…
Some Fizik saddles have a clip in system. This mini-mudguard clips into this receptor. As a mudguard this is of course not 100%, but it protects your behind from getting splashed with dirt. It has a small shield to protect the gap between…
Another filament box. This one is for the box: “Spice & Soul Food Storage Container 4.7l” put upright. It does not have a holder for a hygrometer or silica. You need: 4 x Ball Bearing 608 (8mm inner dia, 22mm outer dia, 7mm width 2x M3 x…
A small box to carry custom earplugs. It has two compartments which open separately. It requires a M3x10mm screw with matching locking nut. The stls are in the intended printing orientation. No support necessary. The 3mf contains all 3…
A mounting system for handlebar bags. The mount has the following features: Integrated bike computer mount for Wahoo bike computers A mounting plate with a spring suspension. This does not work very well, but cushions the hard shocks.…
The printables/thingiverse curse: There are already so many variants of things like this, that it is harder to choose than to create a new one from scratch. So, here you go, another one. This one is for up to 8 blades. The blades are held…
Some Hotels have special clotheshangers without a proper hook. This is an adapter to be able to use the clotheshanger outside its cabinet. I use this to dry clothes in the bathroom of the hotel room. The current size is untested The…
What the name says. This angles the speaker 7° up or down. The bottom is flat, just stick some adhesive feet on it.
A mixed-media bike stand that avoids printing long strips of plastic where a different material is superior. Wooden-Strips Bike Stand A bike stand with wood strips, designed for 700c wheels with tires up to 38mm wide. Prints without…
This is similar to a presser foot for zippers, only with the width of 7mm. The needle has to be on position 0mm on the left side. The axle is a piece of filament. Print on the side, with support.
The spools are stored at an angle, so they do not drop out of the holder that easily. To get the spools out, tilt them horizontal. The holders are stack-able, but the top holder sits on the spools. About 0.5mm are missing. This is fine…
These are all currently available results.
