Counting matching models…
Uses two parts with clips that slide into each other. One part goes on the dock and utilizes the two M2.5 mouting holes. The other part is screwed into the desk and uses any small wood/sheet screw (I use 2.8x13 pan head screws). Printing…
A case for the Sofle v2 keyboard that features magnetically attached lids and tenting feet. This replaces the lower PCB/bottom of the normal Sofle sandwich. I tried to keep the profile as low as possible. The lids account for relatively…
The original side covers of the Behringer X-Touch were too wide to fit a standard 19" rack with an internal dimension of 450mm and also didn't feature any way to mount it to a rail. This model slims down the sides quite a bit, allowing…
A printable tenting puck, which is very similar to the one offered by SplitKB , featuring a ¼" UNC tripod thread and four bolt holes for M2 screws in the 38.1mm pattern. The outside diameter is 42.6mm - please check if this fits if you…
Assembly that screws into the Thunderbolt dock and can be clipped into a Signum cable channel. Allows for easy installation and removal + simple cable routing directly into the cable channel above. The part can be mounted in any…
An insert for the Ergotron LX Series monitor arms for the popular Røde microphone arm. The standard desk mount either had the arm collide with my monitors, as the joint was too low, or obstruct the view. Using this insert, the microphone…
This is an adapter I made to connect my Røde Videomic Go II with a hot shoe mount to the Røde microphone arm using a 3/8" UNC thread. It includes a joint with a thumbscrew to adjust the angle of the microphone. Printing Instructions Hot…
Description A GoPro-compatible mount that attaches to the underside of the Sigma Short or Long Butler. Analogous to the official version from Sigma ( see here ), however with no waiting involved. I used this to mount my headlight along…
These are all currently available results.
