Counting matching models…
Simple Arduino UNO (or Leonardo ) and breadboard holder. I made one because I need some big breadboard holder for my Leonardo. Size of screws - 2,5mm Layer Thickness - on my printer - 0,25mm Designed in Autodesk 123D Design. Print…
I didn't like the fact that the door felt a bit flimsy when opened, so I made this simple part. It requires 2 x small magnets. I used 5x3mm magnets, but you can change parameters of those in project files. Step and Fusion files provided.…
Hi! There are plenty of presses, but I wanted to create one based on linear rods since I had some spare ones. Hardware required: 4x M3x12 screws (M3x10 work well too) 4x M3x36 screws or 4x M3x20 screws (depending on version) 4x LM8UU…
You can use original screw holes in the bed platform to mount those. I used self tapping screws, after drilling screw holes to 2,5mm (in the printed part). You could also use hole compensation parameter in the slicer (Orcaslicer has it…
I wanted to have quick and easy way to check the internal temperature and humidity of the chamber in my printer. Readings of the temperature are not the same as digital ones in the printer's native interface, but it shows the ballpark.…
Print with TPU. Project is split into 2 separate STL files right now.
Simple Raspberry Pi (or Banana Pi) zero stand/holder. All screw holes are 2.5mm screws ready. Can be used vertically and horizontally. There is previous version with no screw-holes on the photo. The STL files contains new version - with…
Print standing on “feet”. Tree supports are good - auto ones should work. Needed mine for HP T730 thin client.
I don't like spoons provided with protein powder so I made my own. Print with PLA. The lower the layer height the better overhangs. No supports needed. Print flat or resting on the bottom overhang.
Hi! I was looking for some simple toothbrush stand for my Oral-B brush. Unfortunately, all models I found had non-round inner pin, so I created my own. Project files attached (you can edit in Fusion360 using parameters or you can download…
I needed simple case for my toothbrush before the travel so I made one. No supports needed, super simple design and easy and quick to print. I used ASA for the main body and PETG for the cover but it doesn't really matter. You can adjust…
I wanted to have the stand for my Taranis, so I designed one. Required hardware: 4x M3x12mm screws 4x M3 nuts (possibly nylon ones are ok too) You can try to use it with just the main part - without screws etc. I used it this way for…
Recently, I built the famous Sofle Keyboard (RGB PCB version in my case). I was trying to find even a simple case. I couldn't find anything that would satisfy my needs, since looks like many people design cases without using heat-set…
Main site of the project: https://github.com/RotorHazard/RotorHazard
Use as the photo implies. You can use X-Y contour compensation in the slicer in case you printer produces different tolerances. Best way to install those it to put the stack modules on the side and then press them from within onto the…
I needed a simple holder to utilize existing holes locations for my new smart lock. Print flat - no supports needed. I advise "with screws" version. Without it only glue is holding the device. Given it is spring loaded - it can detach.
These are all currently available results.
