Counting matching models…
Simple tensioner for a tent guyline or paracord. I have tested the uploaded 3MF/STL files with 550 paracord (~4 mm diameter) as well as narrow tent guyline (~2 mm diameter) and it holds well. Should you need a different size, the source…
Coat hangers for cars that lack built in ones. These are placed over the hand holds above the back doors and secured with a zip tie. As every car and zip tie is different, parametric FreeCAD models are attached where you can edit the…
Wall mount shelf that fits a cable modem "Sagemcom WiFi Hub C2 - F@ST 3890V3 CHWU" The supports below the shelf doubles as convenient points to tie the cables to. The hexagonal holes in the shelf are for ventilation, as the modem has…
Replacement washer for the cords for the parcel shelf/trunk cover of a Dacia Duster 2018+. The factory rubber bar thing is not very well made and easily falls out, it is basically a rubber cross bar that you slide over a knot in the end…
Pins for the side trays below the "floor" of the trunk on a Subaru Legacy Outback 2011 (4th gen). Tested on a European Outback 2011 2.0D (diesel engine) model. I assume it is the same across all variants of the same year at least though.…
This is the support peg for the trunk cover on a Subaru Legacy Outback 2011 (4th gen). This is for the spring loaded side (right side). The shape is the same on the opposite side except the shaft would be different (larger diameter, no…
The original rubber caps on the RAM Mount X-Grip car mount were not long enough to hold my new phone when using a full leather case for the phone. So I made some longer ones. Please note that the 3MF preview looks strange, as there are…
Center flanges for Overture TPU cardboard spools to reduce rolling resistance. I had issues with the friction between the cardboard and the spool holder. This increases the emptier the spool is, as this reduces the mechanical advantage…
A parametric model for plugs in door/window frames. 14 mm diameter by default, but parametric in OnShape model. Prints in vase mode. My old caps in my balcony door frame were crumbling, so I printed new in PETG. Optimised for 0.6 mm…
This converts an old USB Hub (D-Link DUB-1340) I had laying around to a table clamp mount for the back of my desk. Fits a desk that is 2.2 cm thick, with some adjustability. (That part of the CAD model is parametric, so it could be…
Adapter to mount Geekworm X1001 NVME SSD hat to the passively cooled Edatech ED-Pi5Case-B for the Raspberry Pi 5. The included standoffs with the X1001 won't fit, so this is an adapter. Print in PETG or another heat resistant material,…
This is a replacement part for a Deltaco brand tablet stand. The stand has a sticker on it marked “REV3” and “IPD-174”. The part is a component of the hinge mechanism. The original plastic had crumbled after a decade or so. Sliced with…
The rubber parts on my old Deltaco REV3 IPD-174 tablet stand had started to become sticky as the plastic degraded. So I modelled some new parts and printed them in Overture TPU (95 A shore hardness). See also an older model I made for…
Remix of https://www.printables.com/model/1226383-prusa-core-one-magnetic-top-cover-with-integrated for Prusa Core One + (Gen2). The differences are: Removed front handle for sliding the vents, this is done done by internal automatic…
These are all currently available results.
