13 models
Needed a mount to fit beacon probe to EVA2.4 added on mounting block offset is X=0 Y=-35 Sits aound 2.5mm higher than nozzle 20% infill, 0.12 layer height, 0.4 nozzle, 0.4 line width. Support is on, but you have to block most of it
My new Sapphire Plus Toolhead for NF-Crazy Hotend. Please Note that the Bed has to be relocated by about 36mm in y- direction and you are loosing about -10mm in y travel, -5mm in x travel. Klicky Probe using 7x3x2mm Magnets Performing…
I remixed the original Volcano duct to work with my setup that uses the Rapido 2 UHF, Beacon Probe and the awesome RatRig V-Core 3 Extrusionless X-Gantry Mod by elcojacobs . This is the heat insert variety. This will not be usable unless…
Overview: First of all, feel free to ask questions and leave sugestions what to add to the MMU/instructions. I built WKMU based on the working principles of AMS Lite (Didn't know that at the time). It uses 4 secondary stage extruders that…
This is using Eva2.4 because Eva3 is using a different positioning of the Linear rail that is not compatible with the Ender3. Also I had a Titan extruder and that is no longer supported in Eva3. I wanted to use well documented and tested…
My first desighn (that i publish) :) was lookin every where for eva2.4 for ratrig vcore 3 with goliath watercooled hotend, didnt find:\. so did a little remix to the original eva 2.4. on the way remixed and added orbitool mount, and…
This is a simple design I came up with to mount a Duet 1LC board on the print head. It replaces the original strain relief on the tool head while maintaining compatiblity with the original part cooling fan. | No | Qty | Name | Printable |…
you need m3 screws with the 2mm heads The offsets are: X: 37.33 Y:10.25
It had the perfect probe position. You have to use low profile screws. Printable without support. .15mm layer hight gave the best results for me.
This is a remix of three parts to fit the EVA2 carriage (for different extruders and hotends) to an Ender 3, Ender 3V2 or Ender clone with x-axis linear rail installed in front of the 20x20 extrusion profile. Standard EVA2.3.0 only works…
this is a modifyed version of the MK8 Hotend Mod with mounting hole on the site and reducing wheight at the back
you need m3 screws with the 2mm heads The offsets are: X: 37.33 Y:10.25
Overview: First of all, feel free to ask questions and leave sugestions what to add to the MMU/instructions. I built WKMU based on the working principles of AMS Lite (Didn't know that at the time). It uses 4 secondary stage extruders that…
