13 models
Tired of pegs that rust, snap, or vanish into the mystery drawer? This little clip keeps things simple. It is a one-piece design that flexes where it should and holds when it counts. The tapered jaws grab thin fabrics easily, the long…
Print approx. €0.28–€0.34 excl. taxPreliminary estimate for one variant
Did you lose/break the lace lock on your shoes, coat, sweatpants, hoodie, or camping gear? Did they not come with one to begin with? Say goodbye to self-untying shoes and slowly descending sweatpants with this 100% 3D printed gadget.…
A simple and effective design, when you just miss some clothespins. No supports, no brims, no sharp edges. Available with 4 different gap sizes to suit every need. L (4mm gap) M (3mm gap) original design S (2mm gap) XS (1mm gap) Ready to…
I didn't have springs at hand so decided to mod the original design. Test printed with PLA and is quite stiff. I don't know how to analyze how sturdy it is so use at own risk :p
Just a toilet paper spindle in case yours broke. No Springs Needed so Its fully 3D Printable Best Printed with 0.16mm layer height or smaller When installing be sure “Spindle Female.stl” is on the right side to avoid unscrewing while…
This 3D printable cord lock (also known as a cord stopper or toggle) is a practical solution for securing drawstrings on bags, pouches, hoodies, lanyards, or outdoor gear. It’s designed for easy printing without supports and smooth cord…
This is a springless rear suspension design that removes the need for the soft pen/pencil springs used on the rear suspension. Note: I have printed and installed it on my car and it fits perfectly. The spring stiffness feels pretty good…
I needed a solder station for led strips for my Voron 2.4, and didn't want to have to source springs for the currently available models. There are 2 variants of the arms, one with channels for wires the other is flat, both work just fine…
You need to print the original model from @neoyarus. Just replace the cover part with this. I think it should fit for the normal and the tight version.
Since I couldn't order my favorite italian clothpegs in my country, I played a bit with bezier curves in openscad, made a terrible quick and dirty scad file but the thing works for me. Edit (21/02/18): Just improved the openSCAD file…
Recently I needed some basic battery packs for 3 AAs but could not find any that were both simple and robust enough to fit my needs, so I decided to make my own. These packs will allow you to wire 3 AA batteries in series with just a 2 mm…
Added a magnet so we can use our ducts as a drying line Friction fit 5mm diameter magnets. I stacked 3 to increase the hold. Hole is made for taking 3 2mm tall magnets Hole - 5mm by 6mm Maybe add some super glue, but mine work just as…
This is a springless actuator for the American Lock 1100 series padlocks. Unlock the padlock Remove the screw under where the shackle locks Remove the core Close the shackle and push it down a couple of times to make the actuator and ball…
