desk trash can - side mounted, small, lightweight
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple desk trash can to be mounted on the side of a desk.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 65
- Wydruki
- 0
- Wyświetlenia
- 674
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
A desk trash can made to use a small amount of filament while being functional and conserving space on the desk itself.
I recommend using the model with the built in support, as slicers may attempt to put supports in unnecessary places (e.g. the hex lattice or the top of the can. Models should all be printed as oriented. A mouse ear (or regular) brim is strongly recommended! Print speed should be slowed down to avoid knocking any of the delicate bits over.
The wall generator must be set to Arachne, or the line width set to less than 0.4. I would recommend always using Arachne, as many strange artifacts emerge when using the classic wall generator, even with a lower line width.
