Alberta3D De-Stressor Key chain
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A stress test and a Bottle opener for De-Stressing. Test your; Clearance, Stringing, Bridging, Initial Layer, Overhangs
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 51
- Wydruki
- 5
- Wyświetlenia
- 755
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
I created this as an all in one test, with some inspiration from Bugman140 for the Bottle opener idea.
It combines most elements of 3D Printing, all in one small print.
You can check your calibration by measuring Length, Width, & Height 70mm x 35mm x 20mm or 10, respectively
there's an overhang test to see how your printer performs, along with a bridging test to see how far until it droops.
the small uprights, can test your retraction and stringing. as well as show how good your clearances are.
After you've removed the pegs, or broken them off, they'll break flush because the pause will make that layer weak. then you can break off the overhang and Bridging portion.
Then it's a handy key chain bottle opener.
Now you're done stressing over that test. open a cold one and De-stress!
Print Settings
Rafts: No
Supports: No
Resolution: 0.2mm
Infill: 20%
Pause at 6mm to add Coin.
Sized for Can or US quarter, UK 10p, or Aus 10c (thanks Andrew Wombat)