1 / 2
Cohesity Drive Caddy for 2.5 & 3.5 Hard Drives — zdjęcie 1
1 / 2

Cohesity Drive Caddy for 2.5 & 3.5 Hard Drives

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Allows you to insert 2.5" or 3.5" drives into the bays on 2000 series (maybe others) Cohesity rack mount servers.

Ocena
0 / 5
Polubienia
2
Pobrania
28
Wydruki
0
Wyświetlenia
540
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Share Alike

The instructions in the original are still generally applicable to this since not a lot has changed. There is a indent on the Cohesity drive holder that may require some tweaks when printing the 2.5" version.

Here are my relevant settings. I printed these in PLA and haven't had issues, but there are some suggestions on similar models (including the original) to use PETG if your drives get too warm:


Cohesity Caddy Front

  • Probably want to open this as a project in Prusaslicer so that you get all the relevant settings. See screenshot:
  • No supports
  • No brim
  • I add a box modifier in the middle between the two larger holes. This is set to 0 top and bottom layers to allow the infill to come through. You can also just generally set it to 0 top and bottom layers, but I liked the way this looked a bit more.

Cohesity 2.5 Caddy

  • Supports everywhere
  • No brim
  • I added a support blocker for the indented area as the slicer will add them there. I haven't had any issues with no supports there, though you could try it with them. I imagine they may be a bit of a pain to remove though.
  • Again likely just my printer, but I find it less likely that the 90 degree corners lift when I rotate the model about 30-45 degrees instead of the default centre of the bed.

Cohesity 3.5 Caddy

  • Supports on build plate only
  • No brim
  • Again likely just my printer, but I find it less likely that the 90 degree corners lift when I rotate the model about 30-45 degrees instead of the default centre of the bed.

Hope this helps someone else that gets an older Cohesity server without any Drive Caddies!

Tagi