Louqe Raw S1 Rear Fan Bracket - FDM Optimized
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 3D printing optimized version of thearamadon's rear exhaust bracket.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 242
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 3D printing optimized version of thearamadon's rear exhaust bracket for the Louqe Raw S1.
His bracket allows you to mount a gasket on the fan much easier, for much better temps in the case. You will still need to print off the ‘fan bracket gasket adaptors’ from his model page.
This optimized version removes fillet curves, and strengthens the part in a couple areas. The original design was for bent sheet metal.
It also adds a spot to stick a Noctua fan extension cable. This is nice if you have a top fan.
(Check out my other Raw S1 model for a top plate spacer - use an A12x15 top fan with the stock top plate for an unmodified look)
It gets very hot inside the case - print with ASA, PC, or something else that can withstand high temperatures. PLA will most likely warp.
Fusion decided it didn't want to export these in the right orientation - rotate them so the long bar is on the build plate, and the screw holes for mounting are in the air.