Stealth Press 1S - CNC Kitchen Bit Holder

Overview:

Replace the Stealth Press 1S Support Arm with one that can hold the CNC Kitchen Heatset Tips for the TS100/TS101/Pinecil.

Details:

I build the Stealth Press 1S since I had a spare TS100 sitting around after buying a Pinecil. I like it enough that I am less likely to install heatsets freehand now! So I wanted to consolidate my CNC Kitchen Heatset Tips on the press instead of with my Pinecil case.

This part replaces the Support Arms with hardware needed to hold all of the tips from the CNC Kitchen kit. It reuses hardware from the Voron V2 BOM so you might have all you need!

There are two versions; “Compact” and “Double”.

The compact version is a single arm that stays within the original arm footprint. This is a tight fit! Don't put the tips on the screws too tightly or you might have difficulty getting them off.

The double version splits the bits between two arms, print it twice if you want to hold all 6 bits. This one also includes the M3 heatset inserts for accessories since you sacrifice the extra arm that could be used for them and there is more room for it.

I have also added a clamp to hold the iron power cable, it also includes a single heatset hole for even more mounting once it's installed!

BOM:

Instructions:

Slip the M5 x 16mm BHCS fastener through the back, loosely thread the M5 Hex Nut until it touches the printed part. Align the nut and tighten the screw fully with a tool. Make sure this is nice and tight so it won't come free once installed on the press! Feel free to use a little threadlock on the nut but if you do don't let any remain on the threads where the tip will screw on. Attach it to the press with the original four M3 x 8mm BHCS.