1 / 7
2020 Voron clip in thermistor mount and double thermistor mount — zdjęcie 1
1 / 7

2020 Voron clip in thermistor mount and double thermistor mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount a thermistor or two thermistors onto 2020 extrusions quickly without any hardware

Ocena
0 / 5
Polubienia
13
Pobrania
62
Wydruki
0
Wyświetlenia
375
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

If you enjoy this model, please give it a like! This took ages to get right, and I hope to put this kind of effort into more parts. 

2020 Extrusion clip with a 3mm diameter thermistor holder.  No hardware needed at all, just push in and it will click into place!   One is a single holder, the other a double.   

The STEP files should come in the correct orientation - DO NOT ROTATE THEM.  The seam prints on the back where they cannot be seen!  The 3MF file is in the correct orientation, please look at the printing pictures before printing.  Although it will be functional, it won't look nearly as good. 

 

They are designed to print with no support, the legs have the support structure modeled in. The clips can be printed with a .4 or .6mm nozzle.  This was painstakingly tested and revised 23 times.  It was made so the face would look good and the clips strong with no slicer tinkering.  

The 3mf file contains both stl files and has settings that work great.

Very little cleanup if any is needed after you crack off the supports. 

 

Why the double mount?

I wanted a thermistor mount that was similar to the original I found but had the Voron logo rotated 90 degrees for a vertical mount. I also made a double since it is way easier to control active cooling in Klipper using the simple [heater_fan] control vs any complicated macros while also using bed fans.   With bed fans my temps skyrocketed to over 67 degrees C in a Voron Trident 250 on 2 hour prints. The poor little guy was hot to the touch and the doors became very floppy. Before anything broke due to excess heat, two chamber thermistors needed to be installed. One for simple monitoring and bed fan control and the other for active cooling via the Klipper [heater_fan] option. 

 

This is not even close to a remix, but the overall aesthetic was inspired by the work of HenryA and his Voron Chamber Thermistor Mount 2020 extrusion. 

Tagi