Ubiquiti unifi OCD uacc 2U vented panel with fans
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
add fans to your ventilation
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 186
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Added some fans to a ubiquiti ocd panel.
made three versions.
- with own material like 8mm m4 hexbolts and m4 x5x6 heated inserts and m3 6mm hexscrews for mounting the adapter to the OCD panel
- with own material as in point 1 but with an addition of a white 5mm 12v white LED with holder to indicate if fans are on
- UNTESTED!! with the use of the screws that came with the OCD panel, measured the screws so it should fit the adapter but I don't know if those screws are long enough. Also the holes for the fans are smaller to use with the screws supplied with the fans I used
the fans I used are cheap 80mm fans but they are suprisingly good and quiet, for €3.. a piece.
I used some MESH panels to give it a clean look, mounted them underneath for esthetics but for maintenance and cleaning you could do it differently.
this whole operation send me back (excluding the OCD panel) €20
I run the whole thing from an ESP32 connected to Home Assistant so the fans spin up when the temprature gets too high and adjust it accordingly. I reckon you could use every other 80mm fan and control them via the PC motherboard.
have fun!