1 / 4
Film Spacer for FEP or NFEP Vats — zdjęcie 1
1 / 4

Film Spacer for FEP or NFEP Vats

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A spacer used to help create tension for FEP and NFEP replacements on primarily 10" vats such as the Mono m5s I use.

Ocena
0 / 5
Polubienia
1
Pobrania
28
Wydruki
0
Wyświetlenia
112
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a 12mm tall (60mm by 60mm wide) spacer to help create appropriate space to allow for tensioning when tightening screws on the plates and installing back in the Vat.
I was inspired by J3D from Lychee (see YouTube video) as I felt it would be better to have something to hand specifically for this purpose. 
I will likely make some larger or smaller ones if people need them. But so far this worked great on my replacement FEP film.

https://youtu.be/AjofA_mcwzk?si=PT6_S1T4oe5CRqjt&t=745 - Id fully recommend watching the whole video its a great rundown of what FEP and NFEP is and why its good to use a spacer.

There is no specific Material needed, although hardier materials probably are better, I used Elegoo Rapid PTEG BLACK, Infill 5-10% (not really essential and doesn't really shave too much time off the print) I'd recommend Ironing on top layer and to clean it up further you could use fine grit sandpaper and then heat gun to smooth the layer which is what I did. Make sure it is clean and no jagged marks for use.

I hope this is something people find handy!

Use it if you wish, I do not accept responsibility for damage caused in this instance. 

Tagi