Film Spacer for FEP or NFEP Vats
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A spacer used to help create tension for FEP and NFEP replacements on primarily 10" vats such as the Mono m5s I use.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 28
- Makes
- 0
- Views
- 112
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 12mm tall (60mm by 60mm wide) spacer to help create appropriate space to allow for tensioning when tightening screws on the plates and installing back in the Vat.
I was inspired by J3D from Lychee (see YouTube video) as I felt it would be better to have something to hand specifically for this purpose.
I will likely make some larger or smaller ones if people need them. But so far this worked great on my replacement FEP film.
https://youtu.be/AjofA_mcwzk?si=PT6_S1T4oe5CRqjt&t=745 - Id fully recommend watching the whole video its a great rundown of what FEP and NFEP is and why its good to use a spacer.
There is no specific Material needed, although hardier materials probably are better, I used Elegoo Rapid PTEG BLACK, Infill 5-10% (not really essential and doesn't really shave too much time off the print) I'd recommend Ironing on top layer and to clean it up further you could use fine grit sandpaper and then heat gun to smooth the layer which is what I did. Make sure it is clean and no jagged marks for use.
I hope this is something people find handy!
Use it if you wish, I do not accept responsibility for damage caused in this instance.